Published
Sounds like it was diluted with the NS. I received IV potassium while in nursing school. Felt like someone was holding a cigarette lighter to my wrist! I kept slowing it down (this was before the days of pumps...) You might check with the pharmacy for the slowest rate allowable, and/or ask MD if you can slow it down.. Sorry this is not much help.
Do not forget to check your IV site and if it is bad,do not even try to use it. Also if your site is old or getting old you should watch it more closely or change it before. Best to use a small cannula in a large vein. Check your hospital policy but as a general rule you should administer 20 meq over an hour. You can run it at a y-site or as a secondary... or even as a primary intermittent.......but use a pump as a rapid infusion or a free flow can kill your patient. Always know your patients K level before administering. Also review the s/sx of hypokalemia and hyperkalemia.
If the pt. is not allergic to it and MD has no objections, I would ask pharmacy to mix the K with some Lido in the bag.
If my pt. is having a lot of sensitivity to it, I run it as slow as 10 mEq / hr.
You can use the same "set up" but NOT THE SAME RATE! IV magnesium can be infused rapidly - but a rapid infusion of K will only serve to kill your patient (think lethal injection).Would I use the same set-up with a mag run?
cheers,
I used to slow it down until an IV nurse shared with me this does not make the burning any better, it only prolongs the discomfort....CAT
I like getting input from an IV nurse on things, but I've had too many patients tell me the discomfort was indeed resolved by slowing down the infusion to agree with what she told you. Hmmm....
:flowersfo
If we are running a k-ryder, then we ALWAYS run it with a compatible primary to dilute it. We never run potassium alone, it burns like hell and will wreck your IV, not to mention possibly give the patient phlebitis. First make sure your IV site isn't bad, then run it according to how the doc ordered it and really check this, some doc's will ask you to slam it in which could be dangerous. We can't run it faster than 10meq an hour if the patient isn't on a Tele-monitor. We also can get an order for a little lido in the bag. Some people are super sensitive and complain of pain no matter how slow it goes in.
sediaz
20 Posts
I had a pt who needed yet another Potassium run. She told me that it had burned when a previous nurse had run the potassium. Being a new nurse, I went seeking advise on what rate to run the potassium. I was expecting the nurse I asked to tell me to run it slow but she came into the room with me and set up NS going through a pump and primary line connected to the IV site. She then set up the postassium going throug another pump with its primary line connected to the NS tubing at the port closest to the IV site. I don't remember what rates she set the pumps at
but I do know that the patient had no complaints of burning sensation:yeah:. Can someone help me with what the rates might have been? Would I use the same set-up with a mag run?