Another heparin protocol...

Nurses Safety

Published

Ok, my hospital has a very confusing heparin protocol. For example:

Patient weighs 86.4 kg

Initial rate started at 1000 units/hr (12 units/kg/hr) per pharmacy

The heparin bag is 25,000 units in 250 ml

So starting rate is 10 ml/hr

Now the fun begins:

aPTT is 40 sec

Protocol on MAR says:

If aPTT is 35-45 sec increase rate by 150 units/hr (2 units/kg/hr)

I got 12 ml/hr

I used this guide nursing.uchc.edu/.../Heparin%20Drip%20Calculation%20Reference.pdf

Or do you simply add 150 units to the 1000 units/hr for an answer of 11.5 ml/hr?

Thanks!

brithoover

244 Posts

Don't you have a smart pump where you can actually program in units/hr?

nyteshade, BSN

555 Posts

Specializes in Legal, Ortho, Rehab.

Yes, but the question is regarding what is in the patient's MAR: "If aPTT is 35-45 sec increase rate by 150 units/hr (2 units/kg/hr)" if you simply increase by 150 units/hr the result is 11.5 ml (1150 units/hr) or if you use 2 units/kg/hr it is 12 ml/hr (1200 units/hr). If you're supposed to increase by 150 units, then the weight-based answer of 1200 units/hr is 200 units more over the initial 1000...it's a difference of 50 ml/hr something doesn't compute...

The pump will not help in this case.

I'm not sure if my facility is using weight-based and non-weight based calculations. I've seen literature that states some hospitals use both or just weight-based.

psu_213, BSN, RN

3,878 Posts

Specializes in Emergency, Telemetry, Transplant.

This seems like a pretty standard protocol for heparin (in most cases, exactly which protocol is followed is based on the pt's medical dx--NSTEMI, PE, DVT, etc.--that is determined by the doctor).

Our pumps, under our "Guardrail infusions" (Alaris) allow us to enter a weight in kg (technically, for you physics folks, that is their mass, but I digress big time). The you under the dose...for example 12 units/kg/hour. The pump then calculates the drip rate and delivers that. The nomogram then has the drip changes for each aPTT result--i.e. for aPTT 35-45, increase by 2 units/kg/hr (another example could be "for aPTT>150, hold drip for one hour and then decrease rate by 2 units/kg/hour when drip resumes). Going back to your example, if the drip is 12 units/kg/hour and the aPTT comes back at 40, then the pump dose could be set at 14 units/kg/hour. Again, the pump does all of the math and sets/delivers the drip rate. Some facilities require a rate change to be witnessed by a second RN.

If you don't have that type of pump...you were running at 1000 units/hour. Based on the nomogram, you are increasing the dose by 150 units/hour. Which comes out to 1150 units/hour for a drip rate of 11.5 ml/hour.

If possible, heparin drips should be set based on units/hour or units/kg/hour...not based on the drip rate.

psu_213, BSN, RN

3,878 Posts

Specializes in Emergency, Telemetry, Transplant.
Yes, but the question is regarding what is in the patient's MAR: "If aPTT is 35-45 sec increase rate by 150 units/hr (2 units/kg/hr)" if you simply increase by 150 units/hr the result is 11.5 ml (1150 units/hr) or if you use 2 units/kg/hr it is 12 ml/hr (1200 units/hr). A difference of 50 units/hr. The pump will not help in this case.

I'm not sure if my facility is using weight-based and non-weight based calculations. I've seen literature that states some hospitals use both or just weight-based.

What is your facility using for the pt's weight? At one hospital for which I worked, pt weights were rounded off to the nearest 5 kg. Not sure why, since the pump can handle an "odd" weight. Are they using an actual, measured weight, or are they going based on the estimated weight that was entered into the chart when they were in the ER?

nyteshade, BSN

555 Posts

Specializes in Legal, Ortho, Rehab.

The math:

12 units/kg/hr + 2 units/hr is 14 units/kg/hr

14 units x 86.4 kg is 1209.6 units/hr

1209.6 units/ hr x 250 ml is 302,400 divided by 25000 units equals

12.096 or 12 ml/hr

nyteshade, BSN

555 Posts

Specializes in Legal, Ortho, Rehab.

The weight used was 86.4 kg by pharm

nyteshade, BSN

555 Posts

Specializes in Legal, Ortho, Rehab.

"If possible, heparin drips should be set based on units/hour or units/kg/hour...not based on the drip rate"

I totally agree with you there psu.

If pharmacy is putting "increase by 150 units/hr (2 units/kg/hr) isn't the 2 units/kg/hr supposed to result in the same answer? The parenthesis comes across as if the two were equal to each other. This is where I feel something isn't right. If they are supposed to be equal then it should read:

Increase by 200 units/hr (2 units/kg/hr).

This is where I'm lost.

psu_213, BSN, RN

3,878 Posts

Specializes in Emergency, Telemetry, Transplant.

If pharmacy is putting "increase by 150 units/hr (2 units/kg/hr) isn't the 2 units/kg/hr supposed to result in the same answer? The parenthesis comes across as if the two were equal to each other. This is where I feel something isn't right. If they are supposed to be equal then it should read:

Increase by 200 units/hr (2 units/kg/hr).

This sounds like a med error waiting to happen. They should be giving you either a weight based dose (i.e. 12 units/kg/hr to 14 units/kg/hr) or an increase based on just units (i.e. 1000 units/hour to be increased by 150 units/hour). To give both, just makes it more confusing--especially when they don't jive. What is the original doctor's order? Weight based or units/hr?

nyteshade, BSN

555 Posts

Specializes in Legal, Ortho, Rehab.

Well, the doc ordered a cardiac (ACS) protocol, and pharmacy started it at max rate of 1000 units/hr or 12 units/kg/hr (arbitrary for the protocol). Both figures were listed on MAR for the initial start. Pharmacy also noted the pt weight to be used.

I agree it should be either or, and that this is an error waiting to happen.

I just needed fresh eyes to tell me if I am overthinking this or it really does look screwy.

Altra, BSN, RN

6,255 Posts

Specializes in Emergency & Trauma/Adult ICU.

Are you sure you're supposed to factor in the patient's baseline PTT into the initial infusion rate? Everywhere that I have worked, the nomogram order has listed an initial rate, with further instructions to adjust the rate and/or give boluses based on PTT results q 6 hours.

nyteshade, BSN

555 Posts

Specializes in Legal, Ortho, Rehab.

I wasn't trying to calculate the initial rate, pharmacy already set that. This is for a rate change based on aPTT 6 hours after.

+ Add a Comment